For BARKA's cables with plug (optional)
Body in black polypropylene
-
Drill a 31(+1) mm hole in the chosen position considering the 60 mm dia and 10 mm thick base.
-
Pass the plug through the hole, then insert the cable in the side groove of the gland keeping the base on the inlet side.
-
Insert the stem of the gland into the hole, lean the base to the bulkhead keeping the the cable inlet downward and mark the drilling point for the three countersunk fixing screws (not suppplied).
-
To assure a perfect tightness, seal the contact surface between gland and bulkhead and also the holes of the screws.
WARNING: Don't use a too strong sealant to avoid problems in case of dismantling.