INSTALLATION INSTRUCTIONS

• washing and cleaning of every surface with extraordinary NO-SPOT effects with no calcareous residual to be removed after washing, no need for dry and cleanse;
• protection from impurities, chlorine corrosion and calcareous incrustations of pipes, boilers, showers, faucets;
• drinking water improvement when in combination with Atlas Filtri® POU range of filter units (In-Line, Bravo DP, Oasis DP, Depural).
• no power save energy

GENERAL USE REQUIREMENTS
Non-toxic materials, suitable for drinking water, in compliance with the UE “Directive 98/83/EC”.
Control-valve: NORYL.
Frame: painted aluminium/stainless steel AISI 316 L.
Hoses: polyethilene.
Resin tank: glass fiber reinforced polyethilene.
Brine: polystyrene HS-EasyBRINE cartridge with NaCl.
Softening material: strong cationic ion-exchange resin (Na cycle). Volume of the resin 4,5 litres.
Filtering and dechlorination medium: activated carbon block cartridge CB-EC, nominal filtration 10 micron.
Filter housings: reinforced polypropylene, PET.

Remark: the regeneration cartridge HS-EasyBRINE must be changed after every regenaration.
The regeneration ends when all the salt of the HS-EasyBRINE cartridge is consumed.

The average life-time of the filtration CB-EC cartridge is 3-6 months: the life-time depend on the in-let water quality and on the volume of the treated water.
DIMENSIONS 250 x 370 x H 445 mm
WEIGHT 10 kg
WORKING CONDITIONS
Max pressure __________________________6 BAR
Min pressure___________________________2 BAR
Max temperature _______________________45°C
Max Fe________________________________0,1 ppm

SPARE CARTRIDGES FOR ADRIATIC 5

Remark - Adriatic 5 is not a potable water maker: for potable applications use only with safe drinking water.

The volume of the water softened with ADRIATIC 5 depends on the total hardness of the inlet water (the raw water entering the softener). The diagram shows the volumes of treated water at different hardness of the inlet water at 10°f, 20°f, 30°f, 40°f up to 4000 liters after the treatment.
The curves shows the residual hardness at various inlet hardness: on that basis it is possible to operate the regeneration procedure at the preferred residual hardness level. It is recommended to keep the residual hardness below 10°f.